10.10.5.1 router login
To open the admin panel, type 10.10.5.1 into your browser's address bar. If the page does not load, this is probably not the gateway address on your network — see the checks below.
10.10.5.1 router passwords
Where to find them:
- The label on the underside or back of the router — most manufacturers print the default admin username, password and Wi-Fi key there.
- The quick-start card or manual that came in the box.
- Your ISP's account portal, if the device was supplied by them — many set a unique password per line rather than a shared default.
There is no documented default username and password associated with 10.10.5.1. An IP address is not a product, and 10.0.0.0/8 is used by so many different classes of equipment that no credential pair can be attributed to it. Any list claiming otherwise is guessing.
The correct defaults are the ones belonging to your specific device. They are commonly printed on a sticker on the underside or rear panel, alongside the serial number and default wireless key, and repeated in the quick-start guide or the manufacturer's online manual. On ISP-supplied equipment the credentials are often unique per unit and may be listed in your service documentation or account portal rather than on the device.
How to log in to your router
Type 10.10.5.1 into your browser's address bar and press Enter. Type it by hand rather than accepting an autocomplete suggestion, which often fills in a different address you visited before.
If the browser reports that it cannot reach 10.10.5.1, this is not the gateway address on your network. On Windows run ipconfig /all and read the Default Gateway line; on macOS open System Settings, Network, Details, TCP/IP; on Linux run ip route and read the address after "default via".
If the login page loads but rejects your credentials, and you have never changed them, use the defaults printed on the device's label. If they have been changed and nobody knows the new password, a factory reset is the only way back in.
If you do not know the password
If the interface loads but the password is unknown, try the printed defaults first, then any credentials set during installation. On managed or corporate networks the gateway is frequently administered centrally, and the practical route is to ask whoever operates the network rather than to attempt recovery yourself.
A factory reset is the last resort, typically performed by holding a recessed button for roughly ten to thirty seconds while the device is powered on. It restores the printed defaults but also erases the existing configuration: wireless names and keys, DHCP reservations, port forwarding, firewall rules and any ISP-specific provisioning. On ISP equipment that can require a support call to restore service, so back up the configuration beforehand if the device allows it.
10.10.5.1 is a private IPv4 address drawn from 10.0.0.0/8, the largest of the three ranges RFC 1918 reserves for private use. With a netmask of 255.0.0.0 the block spans 16,777,216 addresses, and none of them are routable on the public internet. Because the range is unallocated private space, the same address exists simultaneously on countless unrelated networks: it identifies a device only in relation to whichever network you are currently attached to, and nothing about it can be traced to a location, an operator or a registrant.
In practice 10.0.0.0/8 is almost never deployed as a single flat network. It is subnetted far below /8 and shows up in corporate and campus LANs, ISP-managed customer equipment, carrier-grade access gear, VPN address pools and container or orchestration networks. This particular address sits in the 10.10.5.0/24 subnet, whose usable hosts run from 10.10.5.1 to 10.10.5.254 with 10.10.5.255 reserved as the broadcast address. Being the first usable host, 10.10.5.1 occupies the position commonly assigned to the router, firewall or layer-3 interface that serves the segment.
Most people arriving at this address are trying to open a configuration interface on a device that acts as their gateway, usually to change wireless settings, inspect connected clients, adjust DHCP or forward a port.
Whois information for 10.0.0.0/8
# ARIN WHOIS data and services are subject to the Terms of Use
# available at: https://www.arin.net/resources/registry/whois/tou/
#
# If you see inaccuracies in the results, please report at
# https://www.arin.net/resources/registry/whois/inaccuracy_reporting/
#
# Copyright 1997-2024, American Registry for Internet Numbers, Ltd.
#
NetRange: 10.0.0.0 - 10.255.255.255
CIDR: 10.0.0.0/8
NetName: PRIVATE-ADDRESS-ABLK-RFC1918-IANA-RESERVED
NetHandle: NET-10-0-0-0-1
Parent: ()
NetType: IANA Special Use
OriginAS:
Organization: Internet Assigned Numbers Authority (IANA)
RegDate: 1995-06-23
Updated: 2013-08-30
Comment: These addresses are in use by many millions of independently operated networks, which might be as small as a single computer connected to a home gateway, and are automatically configured in hundreds of millions of devices. They are only intended for use within a private context and traffic that needs to cross the Internet will need to use a different, unique address.
Comment:
Comment: These addresses can be used by anyone without any need to coordinate with IANA or an Internet registry. The traffic from these addresses does not come from ICANN or IANA. We are not the source of activity you may see on logs or in e-mail records. Please refer to http://www.iana.org/abuse/answers
Comment:
Comment: These addresses were assigned by the IETF, the organization that develops Internet protocols, in the Best Current Practice document, RFC 1918 which can be found at:
Comment: http://datatracker.ietf.org/doc/rfc1918
Ref: https://rdap.arin.net/registry/ip/10.0.0.0
OrgName: Internet Assigned Numbers Authority
OrgId: IANA
Address: 12025 Waterfront Drive
Address: Suite 300
City: Los Angeles
StateProv: CA
PostalCode: 90094
Country: US
RegDate:
Updated: 2012-08-31
Ref: https://rdap.arin.net/registry/entity/IANA
OrgAbuseHandle: IANA-IP-ARIN
OrgAbuseName: ICANN
OrgAbusePhone: +1-310-301-5820
OrgAbuseEmail: abuse@iana.org
OrgAbuseRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN
OrgTechHandle: IANA-IP-ARIN
OrgTechName: ICANN
OrgTechPhone: +1-310-301-5820
OrgTechEmail: abuse@iana.org
OrgTechRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN
Other documented addresses in 10.10.5.0/24
The 10.10.5.0/24 subnet runs from 10.10.5.1 to 10.10.5.254, with 10.10.5.255 reserved as the broadcast address. These are the addresses in it we hold router login details for.
All addresses we cover here
16 addresses in this subnet have a page; the most looked-up are listed here.