10.104.24.1 router login

10.104.24.1 router passwords

Where to find them:

• The label on the underside or back of the router — most manufacturers print the default admin username, password and Wi-Fi key there.
• The quick-start card or manual that came in the box.
• Your ISP's account portal, if the device was supplied by them — many set a unique password per line rather than a shared default.

No default username and password pair is documented for this address, and none should be inferred from the fact that it ends in .1. Login details belong to the specific piece of equipment answering here, not to the number itself. On managed hardware the defaults are usually printed on a label on the underside or rear panel, or supplied in the quick-start sheet. On a corporate or campus segment there may be no shared default at all, because the gateway is administered centrally and accounts are issued individually.

How to log in to your router

1. Type 10.104.24.1 into your browser's address bar and press Enter. Type it by hand rather than accepting an autocomplete suggestion, which often fills in a different address you visited before.

2. If the browser reports that it cannot reach 10.104.24.1, this is not the gateway address on your network. On Windows run ipconfig /all and read the Default Gateway line; on macOS open System Settings, Network, Details, TCP/IP; on Linux run ip route and read the address after "default via".

3. If the login page loads but rejects your credentials, and you have never changed them, use the defaults printed on the device's label. If they have been changed and nobody knows the new password, a factory reset is the only way back in.

If you do not know the password

If nobody can sign in, a factory reset restores the documented defaults, but on a gateway serving a whole subnet the cost is high. Reset commonly clears static routes, DHCP scope and reservations, firewall and NAT rules, VLAN configuration and any WAN authentication settings, and the device may come back on a different address entirely, breaking the path you used to reach it. On equipment you do not own or administer, ask the network team first. A configuration backup taken beforehand is the difference between a short outage and a rebuild from memory.