10.112.1.1 router login
To open the admin panel, type 10.112.1.1 into your browser's address bar. If the page does not load, this is probably not the gateway address on your network — see the checks below.
10.112.1.1 router passwords
Where to find them:
- The label on the underside or back of the router — most manufacturers print the default admin username, password and Wi-Fi key there.
- The quick-start card or manual that came in the box.
- Your ISP's account portal, if the device was supplied by them — many set a unique password per line rather than a shared default.
No credential pair is documented for 10.112.1.1, so none is offered. If a login prompt appears when you browse to it, look up the specific hardware behind it: the initial administrator name and password are commonly printed on the device label, listed in the manual, or supplied by the ISP or IT department alongside the equipment. Replace factory defaults once you have access.
How to log in to your router
Type 10.112.1.1 into your browser's address bar and press Enter. Type it by hand rather than accepting an autocomplete suggestion, which often fills in a different address you visited before.
If the browser reports that it cannot reach 10.112.1.1, this is not the gateway address on your network. On Windows run ipconfig /all and read the Default Gateway line; on macOS open System Settings, Network, Details, TCP/IP; on Linux run ip route and read the address after "default via".
If the login page loads but rejects your credentials, and you have never changed them, use the defaults printed on the device's label. If they have been changed and nobody knows the new password, a factory reset is the only way back in.
If you do not know the password
Should the password be genuinely unknown, a hardware reset returns the device to factory state and lets you log in again. On a segment gateway this is costly. Routing, DHCP ranges, VPN configuration and any uplink credentials are erased, and the wireless network reverts to the SSID and key shown on the label. Retrieve or export the configuration beforehand if that is still possible.
This is a private address in 10.0.0.0/8, the largest block reserved by RFC 1918, covering 16,777,216 addresses with the netmask 255.0.0.0. Traffic to 10.112.1.1 stays inside whichever local network you are attached to, and no registrant, operator or country can be attributed to it, because the same address is reused freely and independently everywhere.
Its subnet is 10.112.1.0/24, giving usable hosts between 10.112.1.1 and 10.112.1.254 with 10.112.1.255 as the broadcast address. Being the first usable host, it occupies the position administrators most often assign to a router, layer-three switch interface or firewall serving the segment. Anyone searching for it is generally trying to reach a login screen, verify the gateway their computer is using, or work out why the address appears in their routing table. Our records include one further address in this /24.
Whois information for 10.0.0.0/8
# ARIN WHOIS data and services are subject to the Terms of Use
# available at: https://www.arin.net/resources/registry/whois/tou/
#
# If you see inaccuracies in the results, please report at
# https://www.arin.net/resources/registry/whois/inaccuracy_reporting/
#
# Copyright 1997-2024, American Registry for Internet Numbers, Ltd.
#
NetRange: 10.0.0.0 - 10.255.255.255
CIDR: 10.0.0.0/8
NetName: PRIVATE-ADDRESS-ABLK-RFC1918-IANA-RESERVED
NetHandle: NET-10-0-0-0-1
Parent: ()
NetType: IANA Special Use
OriginAS:
Organization: Internet Assigned Numbers Authority (IANA)
RegDate: 1995-06-23
Updated: 2013-08-30
Comment: These addresses are in use by many millions of independently operated networks, which might be as small as a single computer connected to a home gateway, and are automatically configured in hundreds of millions of devices. They are only intended for use within a private context and traffic that needs to cross the Internet will need to use a different, unique address.
Comment:
Comment: These addresses can be used by anyone without any need to coordinate with IANA or an Internet registry. The traffic from these addresses does not come from ICANN or IANA. We are not the source of activity you may see on logs or in e-mail records. Please refer to http://www.iana.org/abuse/answers
Comment:
Comment: These addresses were assigned by the IETF, the organization that develops Internet protocols, in the Best Current Practice document, RFC 1918 which can be found at:
Comment: http://datatracker.ietf.org/doc/rfc1918
Ref: https://rdap.arin.net/registry/ip/10.0.0.0
OrgName: Internet Assigned Numbers Authority
OrgId: IANA
Address: 12025 Waterfront Drive
Address: Suite 300
City: Los Angeles
StateProv: CA
PostalCode: 90094
Country: US
RegDate:
Updated: 2012-08-31
Ref: https://rdap.arin.net/registry/entity/IANA
OrgAbuseHandle: IANA-IP-ARIN
OrgAbuseName: ICANN
OrgAbusePhone: +1-310-301-5820
OrgAbuseEmail: abuse@iana.org
OrgAbuseRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN
OrgTechHandle: IANA-IP-ARIN
OrgTechName: ICANN
OrgTechPhone: +1-310-301-5820
OrgTechEmail: abuse@iana.org
OrgTechRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN
Other documented addresses in 10.112.1.0/24
The 10.112.1.0/24 subnet runs from 10.112.1.1 to 10.112.1.254, with 10.112.1.255 reserved as the broadcast address. These are the addresses in it we hold router login details for.
All addresses we cover here
2 addresses in this subnet have a page; the most looked-up are listed here.