10.200.13.1 router login

10.200.13.1 router passwords

Where to find them:

• The label on the underside or back of the router — most manufacturers print the default admin username, password and Wi-Fi key there.
• The quick-start card or manual that came in the box.
• Your ISP's account portal, if the device was supplied by them — many set a unique password per line rather than a shared default.

No default login is recorded for 10.200.13.1, and no specific vendor is known to ship this address as a factory gateway, so there is no credential pair that can honestly be quoted.

Gateways at the head of a purpose-numbered subnet are usually routers, firewalls or VPN concentrators under central control. Their factory accounts are commonly replaced during commissioning, and many refuse to operate until an administrator sets one. The authoritative sources are the device label, the vendor's installation documentation, and whoever built the addressing plan this subnet belongs to.

How to log in to your router

1. Type 10.200.13.1 into your browser's address bar and press Enter. Type it by hand rather than accepting an autocomplete suggestion, which often fills in a different address you visited before.

2. If the browser reports that it cannot reach 10.200.13.1, this is not the gateway address on your network. On Windows run ipconfig /all and read the Default Gateway line; on macOS open System Settings, Network, Details, TCP/IP; on Linux run ip route and read the address after "default via".

3. If the login page loads but rejects your credentials, and you have never changed them, use the defaults printed on the device's label. If they have been changed and nobody knows the new password, a factory reset is the only way back in.

If you do not know the password

Because this address is almost certainly a gateway, resetting the device behind it takes the whole subnet offline. Everything using 10.200.13.1 as its next hop loses connectivity until the configuration is rebuilt, and the reset also destroys routing, firewall policy, VPN tunnels, DHCP scopes and NAT rules.

Exhaust the alternatives first: console access over serial, an out-of-band management port, a password-recovery boot mode, or a credential held by the network owner. If a reset is unavoidable, obtain a current configuration backup and a written restore plan before pressing anything, and schedule it as an outage.