10.3.152.1 router login

To open the admin panel, type 10.3.152.1 into your browser's address bar. If the page does not load, this is probably not the gateway address on your network — see the checks below.

10.3.152.1 router passwords

Where to find them:

  • The label on the underside or back of the router — most manufacturers print the default admin username, password and Wi-Fi key there.
  • The quick-start card or manual that came in the box.
  • Your ISP's account portal, if the device was supplied by them — many set a unique password per line rather than a shared default.

No default username and password combination is recorded for 10.3.152.1. That matters more than usual here, because a first-usable-host address is typically routing equipment, and routing equipment in a numbered scheme like this is normally commissioned with credentials chosen by whoever built the network. Any published default would almost certainly have been replaced. The device's own label and its model manual are the correct sources for shipped defaults; for equipment installed by an employer, a contractor or an internet provider, the current credentials sit in their records rather than in any general reference.

How to log in to your router

  1. Type 10.3.152.1 into your browser's address bar and press Enter. Type it by hand rather than accepting an autocomplete suggestion, which often fills in a different address you visited before.

  2. If the browser reports that it cannot reach 10.3.152.1, this is not the gateway address on your network. On Windows run ipconfig /all and read the Default Gateway line; on macOS open System Settings, Network, Details, TCP/IP; on Linux run ip route and read the address after "default via".

  3. If the login page loads but rejects your credentials, and you have never changed them, use the defaults printed on the device's label. If they have been changed and nobody knows the new password, a factory reset is the only way back in.

If you do not know the password

Treat a factory reset at a gateway address as a last resort. If 10.3.152.1 is the default gateway for its subnet, resetting it drops every device behind it off the network until it is reconfigured, and the addressing plan, routing entries, access lists and any VPN or QoS policy vanish with the password. Try credential recovery through the administrator or management platform first. If the hardware is yours and you must proceed, follow the recovery steps in that model's documentation, take a configuration backup beforehand if the interface still responds, and schedule the work for a time when the outage is acceptable.

10.3.152.1 sits in 10.0.0.0/8, the broadest private range RFC 1918 defines. Its 255.0.0.0 mask covers 16,777,216 addresses, which organisations subdivide aggressively; the block is standard in enterprise and campus networks, in provider-supplied customer equipment, in carrier infrastructure, in VPN pools and in container and orchestration networking. Private addressing is not routed publicly and is not allocated to anyone, so no owner or country can be attached to it.

The segment in play is 10.3.152.0/24, usable from 10.3.152.1 to 10.3.152.254 with 10.3.152.255 as the broadcast address. Structured second and third octets like 3 and 152 usually encode something: a region, a site number, a department or a VLAN identifier in a plan drawn up long before any device was plugged in.

What distinguishes this address is its position. The first usable host in a subnet is the classic place to put the default gateway, so 10.3.152.1 is very likely the router or layer-3 switch interface that traffic leaves through, rather than an ordinary client. Only two addresses in the segment are documented, which is consistent with a network whose interior is not publicly described.

Block10.0.0.0/8
Netmask255.0.0.0
Subnet10.3.152.0/24
Usable10.3.152.1 – 10.3.152.254

Whois information for 10.0.0.0/8

#
# ARIN WHOIS data and services are subject to the Terms of Use
# available at: https://www.arin.net/resources/registry/whois/tou/
#
# If you see inaccuracies in the results, please report at
# https://www.arin.net/resources/registry/whois/inaccuracy_reporting/
#
# Copyright 1997-2024, American Registry for Internet Numbers, Ltd.
#


NetRange: 10.0.0.0 - 10.255.255.255
CIDR: 10.0.0.0/8
NetName: PRIVATE-ADDRESS-ABLK-RFC1918-IANA-RESERVED
NetHandle: NET-10-0-0-0-1
Parent:  ()
NetType: IANA Special Use
OriginAS:
Organization: Internet Assigned Numbers Authority (IANA)
RegDate: 1995-06-23
Updated: 2013-08-30
Comment: These addresses are in use by many millions of independently operated networks, which might be as small as a single computer connected to a home gateway, and are automatically configured in hundreds of millions of devices. They are only intended for use within a private context and traffic that needs to cross the Internet will need to use a different, unique address.
Comment:
Comment: These addresses can be used by anyone without any need to coordinate with IANA or an Internet registry. The traffic from these addresses does not come from ICANN or IANA. We are not the source of activity you may see on logs or in e-mail records. Please refer to http://www.iana.org/abuse/answers
Comment:
Comment: These addresses were assigned by the IETF, the organization that develops Internet protocols, in the Best Current Practice document, RFC 1918 which can be found at:
Comment: http://datatracker.ietf.org/doc/rfc1918
Ref: https://rdap.arin.net/registry/ip/10.0.0.0



OrgName: Internet Assigned Numbers Authority
OrgId: IANA
Address: 12025 Waterfront Drive
Address: Suite 300
City: Los Angeles
StateProv: CA
PostalCode: 90094
Country: US
RegDate:
Updated: 2012-08-31
Ref: https://rdap.arin.net/registry/entity/IANA


OrgAbuseHandle: IANA-IP-ARIN
OrgAbuseName: ICANN
OrgAbusePhone: +1-310-301-5820
OrgAbuseEmail: abuse@iana.org
OrgAbuseRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN

OrgTechHandle: IANA-IP-ARIN
OrgTechName: ICANN
OrgTechPhone: +1-310-301-5820
OrgTechEmail: abuse@iana.org
OrgTechRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN

Other documented addresses in 10.3.152.0/24

The 10.3.152.0/24 subnet runs from 10.3.152.1 to 10.3.152.254, with 10.3.152.255 reserved as the broadcast address. These are the addresses in it we hold router login details for.

All addresses we cover here

3 addresses in this subnet have a page; the most looked-up are listed here.