10.45.45.1 router login

10.45.45.1 router passwords

Where to find them:

• The label on the underside or back of the router — most manufacturers print the default admin username, password and Wi-Fi key there.
• The quick-start card or manual that came in the box.
• Your ISP's account portal, if the device was supplied by them — many set a unique password per line rather than a shared default.

Although this address occupies a gateway position, no default username and password is documented for it, and no specific hardware is known to ship it. Do not attempt credentials found elsewhere.

The device answering on 10.45.45.1 has its own factory login, normally printed on a sticker on the case or listed in the manual for that model. Gear configured for VPN or site-to-site duty is often provisioned centrally, so its original password may already have been replaced — in that case the team that deployed the segment holds the working credentials.

How to log in to your router

1. Type 10.45.45.1 into your browser's address bar and press Enter. Type it by hand rather than accepting an autocomplete suggestion, which often fills in a different address you visited before.

2. If the browser reports that it cannot reach 10.45.45.1, this is not the gateway address on your network. On Windows run ipconfig /all and read the Default Gateway line; on macOS open System Settings, Network, Details, TCP/IP; on Linux run ip route and read the address after "default via".

3. If the login page loads but rejects your credentials, and you have never changed them, use the defaults printed on the device's label. If they have been changed and nobody knows the new password, a factory reset is the only way back in.

If you do not know the password

Resetting a gateway costs more than resetting an endpoint, because everything downstream depends on it. A restore to defaults typically removes the 10.45.45.1 address itself, along with DHCP scopes, NAT and firewall policy, VPN tunnels and pre-shared keys, static routes and any DNS forwarding — leaving the whole segment without service until it is rebuilt.

Export or photograph the configuration first if you possibly can. Then, since no vendor is documented here, use the general method: hold the recessed reset control ten to thirty seconds under power and wait for the reboot to complete.