10.80.16.1 router login

To open the admin panel, type 10.80.16.1 into your browser's address bar. If the page does not load, this is probably not the gateway address on your network — see the checks below.

10.80.16.1 router passwords

Where to find them:

  • The label on the underside or back of the router — most manufacturers print the default admin username, password and Wi-Fi key there.
  • The quick-start card or manual that came in the box.
  • Your ISP's account portal, if the device was supplied by them — many set a unique password per line rather than a shared default.

No default username and password pair is documented for 10.80.16.1, and guessing at one is a waste of time. The device's own defaults are usually printed on a sticker on its underside or rear panel, or in the printed quick-start guide. On ISP-supplied equipment the credentials are often account-specific and listed in the provider's documentation or online account portal rather than in any general list.

How to log in to your router

  1. Type 10.80.16.1 into your browser's address bar and press Enter. Type it by hand rather than accepting an autocomplete suggestion, which often fills in a different address you visited before.

  2. If the browser reports that it cannot reach 10.80.16.1, this is not the gateway address on your network. On Windows run ipconfig /all and read the Default Gateway line; on macOS open System Settings, Network, Details, TCP/IP; on Linux run ip route and read the address after "default via".

  3. If the login page loads but rejects your credentials, and you have never changed them, use the defaults printed on the device's label. If they have been changed and nobody knows the new password, a factory reset is the only way back in.

If you do not know the password

If the password is unknown and unrecoverable, most equipment offers a factory reset, typically by holding a recessed button for around ten to thirty seconds while powered on. That reset is not free: it erases custom configuration such as port forwarding, DHCP reservations, firewall rules and any ISP connection settings, and the Wi-Fi network name and password revert to the values printed on the label.

10.80.16.1 is a private IPv4 address inside 10.0.0.0/8, the largest of the three RFC 1918 ranges, with a netmask of 255.0.0.0 and 16,777,216 addresses in total. Because it is private space, it is never routed on the public internet and any organisation may reuse it internally, so no location, ISP or owner can be attached to it. Blocks this size are subnetted far below /8 and turn up in corporate and campus networks, ISP-managed CPE, carrier equipment, VPN address pools and container networks.

Within its own /24 segment, 10.80.16.0/24, the usable range runs from 10.80.16.1 to 10.80.16.254, with 10.80.16.255 reserved as the broadcast address. The .1 position is the first usable host and is commonly assigned to the router or default gateway. Most people looking up this address are trying to open a device's administration page on a network that hands out addresses from this range.

Block10.0.0.0/8
Netmask255.0.0.0
Subnet10.80.16.0/24
Usable10.80.16.1 – 10.80.16.254

Whois information for 10.0.0.0/8

#
# ARIN WHOIS data and services are subject to the Terms of Use
# available at: https://www.arin.net/resources/registry/whois/tou/
#
# If you see inaccuracies in the results, please report at
# https://www.arin.net/resources/registry/whois/inaccuracy_reporting/
#
# Copyright 1997-2024, American Registry for Internet Numbers, Ltd.
#


NetRange: 10.0.0.0 - 10.255.255.255
CIDR: 10.0.0.0/8
NetName: PRIVATE-ADDRESS-ABLK-RFC1918-IANA-RESERVED
NetHandle: NET-10-0-0-0-1
Parent:  ()
NetType: IANA Special Use
OriginAS:
Organization: Internet Assigned Numbers Authority (IANA)
RegDate: 1995-06-23
Updated: 2013-08-30
Comment: These addresses are in use by many millions of independently operated networks, which might be as small as a single computer connected to a home gateway, and are automatically configured in hundreds of millions of devices. They are only intended for use within a private context and traffic that needs to cross the Internet will need to use a different, unique address.
Comment:
Comment: These addresses can be used by anyone without any need to coordinate with IANA or an Internet registry. The traffic from these addresses does not come from ICANN or IANA. We are not the source of activity you may see on logs or in e-mail records. Please refer to http://www.iana.org/abuse/answers
Comment:
Comment: These addresses were assigned by the IETF, the organization that develops Internet protocols, in the Best Current Practice document, RFC 1918 which can be found at:
Comment: http://datatracker.ietf.org/doc/rfc1918
Ref: https://rdap.arin.net/registry/ip/10.0.0.0



OrgName: Internet Assigned Numbers Authority
OrgId: IANA
Address: 12025 Waterfront Drive
Address: Suite 300
City: Los Angeles
StateProv: CA
PostalCode: 90094
Country: US
RegDate:
Updated: 2012-08-31
Ref: https://rdap.arin.net/registry/entity/IANA


OrgAbuseHandle: IANA-IP-ARIN
OrgAbuseName: ICANN
OrgAbusePhone: +1-310-301-5820
OrgAbuseEmail: abuse@iana.org
OrgAbuseRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN

OrgTechHandle: IANA-IP-ARIN
OrgTechName: ICANN
OrgTechPhone: +1-310-301-5820
OrgTechEmail: abuse@iana.org
OrgTechRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN