192.168.0.130 router login
To open the admin panel, type 192.168.0.130 into your browser's address bar. If the page does not load, this is probably not the gateway address on your network — see the checks below.
192.168.0.130 router passwords
Where to find them:
- The label on the underside or back of the router — most manufacturers print the default admin username, password and Wi-Fi key there.
- The quick-start card or manual that came in the box.
- Your ISP's account portal, if the device was supplied by them — many set a unique password per line rather than a shared default.
There are no documented default username and password pairs for 192.168.0.130. That is expected rather than an omission: a private address says nothing about what device holds it, so any credential list attached to the number itself would be guesswork. Defaults belong to the hardware, not the address.
To find the real ones, check the label printed on the device, usually on its underside or rear panel, where the default login and any unique per-unit password are commonly shown. Failing that, consult the printed or downloadable manual for the exact model, or your service provider's documentation if the equipment was supplied with your connection.
How to log in to your router
Type 192.168.0.130 into your browser's address bar and press Enter. Type it by hand rather than accepting an autocomplete suggestion, which often fills in a different address you visited before.
If the browser reports that it cannot reach 192.168.0.130, this is not the gateway address on your network. On Windows run ipconfig /all and read the Default Gateway line; on macOS open System Settings, Network, Details, TCP/IP; on Linux run ip route and read the address after "default via".
If the login page loads but rejects your credentials, and you have never changed them, use the defaults printed on the device's label. If they have been changed and nobody knows the new password, a factory reset is the only way back in.
If you do not know the password
If the login page at this address rejects every credential you have, and the device is one you own or administer, a factory reset is the usual last resort. On most equipment this means holding a small recessed button, often marked reset and reachable with a paperclip, for roughly ten to thirty seconds while the unit is powered on. Since no specific vendor is known to ship this address, follow the procedure documented for your own model rather than a generic one.
Weigh the cost first. A reset commonly clears the wireless network name and passphrase, port forwarding, static leases, parental controls and any provider-specific connection settings, so the network may need rebuilding from scratch afterwards. Record what you can before resetting.
192.168.0.130 is a private IPv4 address drawn from 192.168.0.0/16, the RFC 1918 range reserved for private use. With a netmask of 255.255.0.0 that block holds 65,536 addresses, and none of them are routable across the public internet. This is the consumer block: nearly every home router, mobile hotspot and small office access point ships a default gateway inside it, which is why it is the range most people encounter. Because the space is reusable by anyone, the same address exists simultaneously on millions of unrelated networks, and no location, internet provider or organisation can be attributed to it.
Within that block, this address sits in the 192.168.0.0/24 subnet, whose usable host range runs from 192.168.0.1 to 192.168.0.254 with 192.168.0.255 reserved as the broadcast address. It occupies host position 130, well inside the span that DHCP servers on many consumer routers hand out automatically. That is not a position routers typically take for themselves, so on a typical network this address belongs to a client: a laptop, phone, printer, camera, NAS or smart-home device that was leased the address rather than configured with it.
Most people who look up 192.168.0.130 have found it in a router's client list, a network scan or a device's own status screen, and want to know what is answering there and how to open its configuration page.
Whois information for 192.168.0.0/16
# ARIN WHOIS data and services are subject to the Terms of Use
# available at: https://www.arin.net/resources/registry/whois/tou/
#
# If you see inaccuracies in the results, please report at
# https://www.arin.net/resources/registry/whois/inaccuracy_reporting/
#
# Copyright 1997-2024, American Registry for Internet Numbers, Ltd.
#
NetRange: 192.168.0.0 - 192.168.255.255
CIDR: 192.168.0.0/16
NetName: PRIVATE-ADDRESS-CBLK-RFC1918-IANA-RESERVED
NetHandle: NET-192-168-0-0-1
Parent: NET192 (NET-192-0-0-0-0)
NetType: IANA Special Use
OriginAS:
Organization: Internet Assigned Numbers Authority (IANA)
RegDate: 1994-03-15
Updated: 2013-08-30
Comment: These addresses are in use by many millions of independently operated networks, which might be as small as a single computer connected to a home gateway, and are automatically configured in hundreds of millions of devices. They are only intended for use within a private context and traffic that needs to cross the Internet will need to use a different, unique address.
Comment:
Comment: These addresses can be used by anyone without any need to coordinate with IANA or an Internet registry. The traffic from these addresses does not come from ICANN or IANA. We are not the source of activity you may see on logs or in e-mail records. Please refer to http://www.iana.org/abuse/answers
Comment:
Comment: These addresses were assigned by the IETF, the organization that develops Internet protocols, in the Best Current Practice document, RFC 1918 which can be found at:
Comment: http://datatracker.ietf.org/doc/rfc1918
Ref: https://rdap.arin.net/registry/ip/192.168.0.0
OrgName: Internet Assigned Numbers Authority
OrgId: IANA
Address: 12025 Waterfront Drive
Address: Suite 300
City: Los Angeles
StateProv: CA
PostalCode: 90094
Country: US
RegDate:
Updated: 2012-08-31
Ref: https://rdap.arin.net/registry/entity/IANA
OrgAbuseHandle: IANA-IP-ARIN
OrgAbuseName: ICANN
OrgAbusePhone: +1-310-301-5820
OrgAbuseEmail: abuse@iana.org
OrgAbuseRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN
OrgTechHandle: IANA-IP-ARIN
OrgTechName: ICANN
OrgTechPhone: +1-310-301-5820
OrgTechEmail: abuse@iana.org
OrgTechRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN
Other documented addresses in 192.168.0.0/24
The 192.168.0.0/24 subnet runs from 192.168.0.1 to 192.168.0.254, with 192.168.0.255 reserved as the broadcast address. These are the addresses in it we hold router login details for.
Most looked up in this subnet
All addresses we cover here
250 addresses in this subnet have a page; the most looked-up are listed here.