10.0.0.10 router login

To open the admin panel, type 10.0.0.10 into your browser's address bar. If the page does not load, this is probably not the gateway address on your network — see the checks below.

10.0.0.10 router passwords

One default username and password pair has been reported for devices answering on 10.0.0.10.

Username / Password Percentage
blank / blank 100%

No username and password pair is documented for 10.0.0.10, which is what you would expect: an address is not a product, and whatever responds on it brings its own login. On many devices the credentials were set during first-time setup rather than left at a factory default, so even a correct vendor default may no longer apply.

Check the label or sticker on the underside or rear of the unit, the manual or quick-start guide, or the documentation supplied by your internet provider if the equipment came from them. Treat any list that claims to know the login for an address, rather than for a specific model, with suspicion.

How to log in to your router

  1. Type 10.0.0.10 into your browser's address bar and press Enter. Type it by hand rather than accepting an autocomplete suggestion, which often fills in a different address you visited before.

  2. If the browser reports that it cannot reach 10.0.0.10, this is not the gateway address on your network. On Windows run ipconfig /all and read the Default Gateway line; on macOS open System Settings, Network, Details, TCP/IP; on Linux run ip route and read the address after "default via".

  3. If the login page loads but rejects your credentials, and you have never changed them, use the defaults printed on the device's label. If they have been changed and nobody knows the new password, a factory reset is the only way back in.

If you do not know the password

If the page loads but no credentials work, a factory reset is the usual last resort, and it is not free. It clears the Wi-Fi network name and password, port forwarding, static leases, firewall rules and, on provider-supplied equipment, sometimes the provisioning details needed to get back online. The device may also come back on a different address afterwards, so 10.0.0.10 may no longer reach it.

No specific vendor is known to ship this address as a default gateway, so follow the reset procedure in the device's own documentation. Commonly it is a recessed button held for roughly ten to thirty seconds while the unit is powered on. Export the configuration first if the interface allows it.

10.0.0.10 is a private IPv4 address inside 10.0.0.0/8, the largest of the RFC 1918 ranges. With a netmask of 255.0.0.0 the block holds 16,777,216 addresses, none of which are routable across the public internet. The same address is in use simultaneously on countless unrelated networks, so it carries no location, owner or internet provider of its own; it identifies only a host on whichever local network you happen to be attached to.

Because a /8 is far too large to run flat, it is normally subnetted well below that size. The subnet around this address is commonly 10.0.0.0/24, with usable hosts from 10.0.0.1 to 10.0.0.254 and 10.0.0.255 reserved for broadcast. 10.0.0.10 is the tenth usable position, which is not where gateways usually sit — in a /24 they are most often at the first or last usable address. Ranges from this block turn up in corporate and campus networks, ISP-managed CPE, carrier equipment, VPN address pools and container networking.

A low, round number like .10 is more often a static assignment or DHCP reservation: a server, NAS, printer, access point, controller or management interface. Most people looking this address up want to open a management page at http://10.0.0.10, or to work out which device answers there before signing in.

Block10.0.0.0/8
Netmask255.0.0.0
Subnet10.0.0.0/24
Usable10.0.0.1 – 10.0.0.254

Whois information for 10.0.0.0/8

#
# ARIN WHOIS data and services are subject to the Terms of Use
# available at: https://www.arin.net/resources/registry/whois/tou/
#
# If you see inaccuracies in the results, please report at
# https://www.arin.net/resources/registry/whois/inaccuracy_reporting/
#
# Copyright 1997-2024, American Registry for Internet Numbers, Ltd.
#


NetRange: 10.0.0.0 - 10.255.255.255
CIDR: 10.0.0.0/8
NetName: PRIVATE-ADDRESS-ABLK-RFC1918-IANA-RESERVED
NetHandle: NET-10-0-0-0-1
Parent:  ()
NetType: IANA Special Use
OriginAS:
Organization: Internet Assigned Numbers Authority (IANA)
RegDate: 1995-06-23
Updated: 2013-08-30
Comment: These addresses are in use by many millions of independently operated networks, which might be as small as a single computer connected to a home gateway, and are automatically configured in hundreds of millions of devices. They are only intended for use within a private context and traffic that needs to cross the Internet will need to use a different, unique address.
Comment:
Comment: These addresses can be used by anyone without any need to coordinate with IANA or an Internet registry. The traffic from these addresses does not come from ICANN or IANA. We are not the source of activity you may see on logs or in e-mail records. Please refer to http://www.iana.org/abuse/answers
Comment:
Comment: These addresses were assigned by the IETF, the organization that develops Internet protocols, in the Best Current Practice document, RFC 1918 which can be found at:
Comment: http://datatracker.ietf.org/doc/rfc1918
Ref: https://rdap.arin.net/registry/ip/10.0.0.0



OrgName: Internet Assigned Numbers Authority
OrgId: IANA
Address: 12025 Waterfront Drive
Address: Suite 300
City: Los Angeles
StateProv: CA
PostalCode: 90094
Country: US
RegDate:
Updated: 2012-08-31
Ref: https://rdap.arin.net/registry/entity/IANA


OrgAbuseHandle: IANA-IP-ARIN
OrgAbuseName: ICANN
OrgAbusePhone: +1-310-301-5820
OrgAbuseEmail: abuse@iana.org
OrgAbuseRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN

OrgTechHandle: IANA-IP-ARIN
OrgTechName: ICANN
OrgTechPhone: +1-310-301-5820
OrgTechEmail: abuse@iana.org
OrgTechRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN

Other documented addresses in 10.0.0.0/24

The 10.0.0.0/24 subnet runs from 10.0.0.1 to 10.0.0.254, with 10.0.0.255 reserved as the broadcast address. These are the addresses in it we hold router login details for.

Most looked up in this subnet

All addresses we cover here

255 addresses in this subnet have a page; the most looked-up are listed here.