10.0.0.46 router login

http://10.0.0.46 ↗

To open the admin panel, type 10.0.0.46 into your browser's address bar. If the page does not load, this is probably not the gateway address on your network — see the checks below.

10.0.0.46 router passwords

Where to find them:

  • The label on the underside or back of the router — most manufacturers print the default admin username, password and Wi-Fi key there.
  • The quick-start card or manual that came in the box.
  • Your ISP's account portal, if the device was supplied by them — many set a unique password per line rather than a shared default.

No default username and password pair is recorded for 10.0.0.46, and none can be inferred from the address itself: credentials belong to a particular device and firmware, and any device on any private network may hold this address. Check the label printed on the underside or rear of the unit, the printed quick-start guide, or the manufacturer's manual for that model. Many devices shipped in recent years use a per-unit randomised password on the label rather than a shared default. For ISP-supplied equipment, the provider's own support documentation or account portal is usually the authoritative source.

How to log in to your router

  1. Type 10.0.0.46 into your browser's address bar and press Enter. Type it by hand rather than accepting an autocomplete suggestion, which often fills in a different address you visited before.

  2. If the browser reports that it cannot reach 10.0.0.46, this is not the gateway address on your network. On Windows run ipconfig /all and read the Default Gateway line; on macOS open System Settings, Network, Details, TCP/IP; on Linux run ip route and read the address after "default via".

  3. If the login page loads but rejects your credentials, and you have never changed them, use the defaults printed on the device's label. If they have been changed and nobody knows the new password, a factory reset is the only way back in.

If you do not know the password

No specific vendor is known to ship 10.0.0.46 as a default address, so no vendor-specific reset procedure applies. On many devices a factory reset means holding a recessed button with a paperclip for roughly ten to thirty seconds while the unit is powered on. Treat it as a last resort: it commonly clears the Wi-Fi name and passphrase, port forwarding, static leases, VLANs and any PPPoE or ISP login, and the device returns to its own default address, which may no longer be 10.0.0.46. Before resetting, export a configuration backup if the interface allows it. ISP-managed equipment may need re-provisioning by the provider afterwards.

The address 10.0.0.46 belongs to 10.0.0.0/8, the largest of the three RFC 1918 private ranges: a netmask of 255.0.0.0 covering 16,777,216 addresses. Traffic to it is never routed across the public internet, and the same address is in use simultaneously on countless unrelated networks, so it has no registrant, operator or geographic location of its own.

Within a network that follows the common layout, 10.0.0.46 falls in the 10.0.0.0/24 subnet, whose usable hosts run from 10.0.0.1 to 10.0.0.254 with 10.0.0.255 reserved as the broadcast address. Position 46 sits in the middle of that range rather than at the low or high edges where gateways are usually placed, so on many networks it is a DHCP-assigned client or a statically reserved host — a server, printer, access point, camera or storage appliance — rather than the router. The /8 block as a whole is common in corporate and campus networks, ISP-managed CPE, carrier-grade equipment, VPN address pools and container or orchestration networks, where it is always subnetted far below /8.

Most people looking up this address have found it in a DHCP lease table, an ARP listing or a network scan and want to know what answers there, reach a web interface at http://10.0.0.46, or sign in to it. That is only possible from a device attached to the same private network.

Block10.0.0.0/8
Netmask255.0.0.0
Subnet10.0.0.0/24
Usable10.0.0.1 – 10.0.0.254

Whois information for 10.0.0.0/8
#
# ARIN WHOIS data and services are subject to the Terms of Use
# available at: https://www.arin.net/resources/registry/whois/tou/
#
# If you see inaccuracies in the results, please report at
# https://www.arin.net/resources/registry/whois/inaccuracy_reporting/
#
# Copyright 1997-2024, American Registry for Internet Numbers, Ltd.
#


NetRange: 10.0.0.0 - 10.255.255.255
CIDR: 10.0.0.0/8
NetName: PRIVATE-ADDRESS-ABLK-RFC1918-IANA-RESERVED
NetHandle: NET-10-0-0-0-1
Parent:  ()
NetType: IANA Special Use
OriginAS:
Organization: Internet Assigned Numbers Authority (IANA)
RegDate: 1995-06-23
Updated: 2013-08-30
Comment: These addresses are in use by many millions of independently operated networks, which might be as small as a single computer connected to a home gateway, and are automatically configured in hundreds of millions of devices. They are only intended for use within a private context and traffic that needs to cross the Internet will need to use a different, unique address.
Comment:
Comment: These addresses can be used by anyone without any need to coordinate with IANA or an Internet registry. The traffic from these addresses does not come from ICANN or IANA. We are not the source of activity you may see on logs or in e-mail records. Please refer to http://www.iana.org/abuse/answers
Comment:
Comment: These addresses were assigned by the IETF, the organization that develops Internet protocols, in the Best Current Practice document, RFC 1918 which can be found at:
Comment: http://datatracker.ietf.org/doc/rfc1918
Ref: https://rdap.arin.net/registry/ip/10.0.0.0



OrgName: Internet Assigned Numbers Authority
OrgId: IANA
Address: 12025 Waterfront Drive
Address: Suite 300
City: Los Angeles
StateProv: CA
PostalCode: 90094
Country: US
RegDate:
Updated: 2012-08-31
Ref: https://rdap.arin.net/registry/entity/IANA


OrgAbuseHandle: IANA-IP-ARIN
OrgAbuseName: ICANN
OrgAbusePhone: +1-310-301-5820
OrgAbuseEmail: abuse@iana.org
OrgAbuseRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN

OrgTechHandle: IANA-IP-ARIN
OrgTechName: ICANN
OrgTechPhone: +1-310-301-5820
OrgTechEmail: abuse@iana.org
OrgTechRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN

Other documented addresses in 10.0.0.0/24

The 10.0.0.0/24 subnet runs from 10.0.0.1 to 10.0.0.254, with 10.0.0.255 reserved as the broadcast address. These are the addresses in it we hold router login details for.

Most looked up in this subnet

10.0.0.5 10.0.0.8 10.0.0.253 10.0.0.251 10.0.0.245 10.0.0.36 10.0.0.254 10.0.0.24

All addresses we cover here
10.0.0.2 10.0.0.4 10.0.0.5 10.0.0.6 10.0.0.7 10.0.0.8 10.0.0.9 10.0.0.10 10.0.0.12 10.0.0.14 10.0.0.15 10.0.0.16 10.0.0.18 10.0.0.24 10.0.0.25 10.0.0.26 10.0.0.27 10.0.0.32 10.0.0.33 10.0.0.35 10.0.0.36 10.0.0.38 10.0.0.39 10.0.0.40 10.0.0.42 10.0.0.43 10.0.0.44 10.0.0.45 10.0.0.52 10.0.0.53 10.0.0.54 10.0.0.55 10.0.0.56 10.0.0.59 10.0.0.63 10.0.0.64 10.0.0.65 10.0.0.66 10.0.0.67 10.0.0.71 10.0.0.75 10.0.0.76 10.0.0.77 10.0.0.81 10.0.0.85 10.0.0.90 10.0.0.91 10.0.0.95 10.0.0.97 10.0.0.124 10.0.0.143 10.0.0.172 10.0.0.181 10.0.0.245 10.0.0.249 10.0.0.250 10.0.0.251 10.0.0.252 10.0.0.253 10.0.0.254

255 addresses in this subnet have a page; the most looked-up are listed here.