192.168.100.148 router login
To open the admin panel, type 192.168.100.148 into your browser's address bar. If the page does not load, this is probably not the gateway address on your network — see the checks below.
192.168.100.148 router passwords
Where to find them:
- The label on the underside or back of the router — most manufacturers print the default admin username, password and Wi-Fi key there.
- The quick-start card or manual that came in the box.
- Your ISP's account portal, if the device was supplied by them — many set a unique password per line rather than a shared default.
There is no known default login associated with this particular address, so treat any list claiming otherwise with suspicion. The device's own defaults are the only reliable source: the underside or rear sticker normally carries them, and the manual or an ISP welcome pack covers equipment that ships without printed credentials. Passwords changed during setup override anything printed.
How to log in to your router
Type 192.168.100.148 into your browser's address bar and press Enter. Type it by hand rather than accepting an autocomplete suggestion, which often fills in a different address you visited before.
If the browser reports that it cannot reach 192.168.100.148, this is not the gateway address on your network. On Windows run ipconfig /all and read the Default Gateway line; on macOS open System Settings, Network, Details, TCP/IP; on Linux run ip route and read the address after "default via".
If the login page loads but rejects your credentials, and you have never changed them, use the defaults printed on the device's label. If they have been changed and nobody knows the new password, a factory reset is the only way back in.
If you do not know the password
When the password is genuinely lost, a factory reset is the last resort. Holding the reset pinhole down while powered clears the stored configuration entirely, so VLANs, forwarded ports, guest networks and firmware-level tweaks all disappear. The wireless name and passphrase drop back to the values on the label, meaning phones, TVs and smart plugs will need reconnecting before the network behaves normally again.
This address belongs to 192.168.0.0/16, the private range defined by RFC 1918 and carrying 65,536 addresses under a 255.255.0.0 netmask. Because consumer gear overwhelmingly defaults into this block, the same figure appears on countless separate networks at once. That reuse is the point of private addressing, and it means no registrant, carrier or country can be attached to 192.168.100.148 in any meaningful way.
Within the network it belongs to, the relevant subnet is 192.168.100.0/24. Usable hosts run from 192.168.100.1 to 192.168.100.254, and 192.168.100.255 is the broadcast address. Host number 148 falls in the middle of the pool, a spot that dynamic assignment tends to fill rather than a fixed gateway slot. Visitors typing this into a browser are usually chasing an admin panel they saw referenced somewhere, or trying to identify a device that turned up unexpectedly on their own LAN.
Whois information for 192.168.0.0/16
# ARIN WHOIS data and services are subject to the Terms of Use
# available at: https://www.arin.net/resources/registry/whois/tou/
#
# If you see inaccuracies in the results, please report at
# https://www.arin.net/resources/registry/whois/inaccuracy_reporting/
#
# Copyright 1997-2024, American Registry for Internet Numbers, Ltd.
#
NetRange: 192.168.0.0 - 192.168.255.255
CIDR: 192.168.0.0/16
NetName: PRIVATE-ADDRESS-CBLK-RFC1918-IANA-RESERVED
NetHandle: NET-192-168-0-0-1
Parent: NET192 (NET-192-0-0-0-0)
NetType: IANA Special Use
OriginAS:
Organization: Internet Assigned Numbers Authority (IANA)
RegDate: 1994-03-15
Updated: 2013-08-30
Comment: These addresses are in use by many millions of independently operated networks, which might be as small as a single computer connected to a home gateway, and are automatically configured in hundreds of millions of devices. They are only intended for use within a private context and traffic that needs to cross the Internet will need to use a different, unique address.
Comment:
Comment: These addresses can be used by anyone without any need to coordinate with IANA or an Internet registry. The traffic from these addresses does not come from ICANN or IANA. We are not the source of activity you may see on logs or in e-mail records. Please refer to http://www.iana.org/abuse/answers
Comment:
Comment: These addresses were assigned by the IETF, the organization that develops Internet protocols, in the Best Current Practice document, RFC 1918 which can be found at:
Comment: http://datatracker.ietf.org/doc/rfc1918
Ref: https://rdap.arin.net/registry/ip/192.168.0.0
OrgName: Internet Assigned Numbers Authority
OrgId: IANA
Address: 12025 Waterfront Drive
Address: Suite 300
City: Los Angeles
StateProv: CA
PostalCode: 90094
Country: US
RegDate:
Updated: 2012-08-31
Ref: https://rdap.arin.net/registry/entity/IANA
OrgAbuseHandle: IANA-IP-ARIN
OrgAbuseName: ICANN
OrgAbusePhone: +1-310-301-5820
OrgAbuseEmail: abuse@iana.org
OrgAbuseRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN
OrgTechHandle: IANA-IP-ARIN
OrgTechName: ICANN
OrgTechPhone: +1-310-301-5820
OrgTechEmail: abuse@iana.org
OrgTechRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN
Other documented addresses in 192.168.100.0/24
The 192.168.100.0/24 subnet runs from 192.168.100.1 to 192.168.100.254, with 192.168.100.255 reserved as the broadcast address. These are the addresses in it we hold router login details for.
Most looked up in this subnet
All addresses we cover here
255 addresses in this subnet have a page; the most looked-up are listed here.