10.0.0.13 router login

http://10.0.0.13 ↗

To open the admin panel, type 10.0.0.13 into your browser's address bar. If the page does not load, this is probably not the gateway address on your network — see the checks below.

10.0.0.13 router passwords

Where to find them:

  • The label on the underside or back of the router — most manufacturers print the default admin username, password and Wi-Fi key there.
  • The quick-start card or manual that came in the box.
  • Your ISP's account portal, if the device was supplied by them — many set a unique password per line rather than a shared default.

No default username and password pair is documented for 10.0.0.13. That is expected: credentials belong to a particular device model, not to a private address that any network can reuse, and no vendor is known to ship this address as a factory default.

The defaults that matter are the ones printed on the device itself. Check the label on the underside or rear panel, the quick-start card in the box, or the manufacturer's manual for that exact model. On equipment supplied by an ISP, the credentials are often set by the provider and appear in their account portal or setup documentation rather than on the vendor's site.

How to log in to your router

  1. Type 10.0.0.13 into your browser's address bar and press Enter. Type it by hand rather than accepting an autocomplete suggestion, which often fills in a different address you visited before.

  2. If the browser reports that it cannot reach 10.0.0.13, this is not the gateway address on your network. On Windows run ipconfig /all and read the Default Gateway line; on macOS open System Settings, Network, Details, TCP/IP; on Linux run ip route and read the address after "default via".

  3. If the login page loads but rejects your credentials, and you have never changed them, use the defaults printed on the device's label. If they have been changed and nobody knows the new password, a factory reset is the only way back in.

If you do not know the password

If the login is unknown and no label or documentation is available, a factory reset restores the device's original credentials. Treat it as a last step. A reset erases the current configuration: wireless network names and keys, port forwarding, static leases, firewall rules, VLAN and VPN settings, and any ISP-specific provisioning, all of which have to be entered again afterwards.

Since no vendor is identified for this address, follow the reset procedure in the device's own manual. Most units use a recessed button held for roughly ten to thirty seconds while powered on. Export or photograph the existing configuration first where the interface allows it.

The address 10.0.0.13 belongs to 10.0.0.0/8, the largest of the three private ranges set aside by RFC 1918. With a netmask of 255.0.0.0, the block spans 16,777,216 addresses, and none of them are routable across the public internet. That size is why the block turns up in corporate and campus networks, ISP-managed customer equipment, carrier-grade gear, VPN address pools and container or orchestration networks, almost always subnetted far below /8 into smaller segments.

In practice this address is usually read as part of a /24 segment, 10.0.0.0/24, whose usable host range runs from 10.0.0.1 to 10.0.0.254 with 10.0.0.255 reserved as the broadcast address. At position 13 in that range, 10.0.0.13 sits in the body of the DHCP or static pool rather than at the low positions such as .1 or .254 that are commonly chosen for a gateway.

Because the address is private, the same value exists independently on countless unrelated networks, and no location, provider or owner can be inferred from it. Someone looking it up is typically trying to identify a device that appeared on their own LAN, reach a host's management interface, or work out whether a device on that segment is the router at all.

Block10.0.0.0/8
Netmask255.0.0.0
Subnet10.0.0.0/24
Usable10.0.0.1 – 10.0.0.254

Whois information for 10.0.0.0/8
#
# ARIN WHOIS data and services are subject to the Terms of Use
# available at: https://www.arin.net/resources/registry/whois/tou/
#
# If you see inaccuracies in the results, please report at
# https://www.arin.net/resources/registry/whois/inaccuracy_reporting/
#
# Copyright 1997-2024, American Registry for Internet Numbers, Ltd.
#


NetRange: 10.0.0.0 - 10.255.255.255
CIDR: 10.0.0.0/8
NetName: PRIVATE-ADDRESS-ABLK-RFC1918-IANA-RESERVED
NetHandle: NET-10-0-0-0-1
Parent:  ()
NetType: IANA Special Use
OriginAS:
Organization: Internet Assigned Numbers Authority (IANA)
RegDate: 1995-06-23
Updated: 2013-08-30
Comment: These addresses are in use by many millions of independently operated networks, which might be as small as a single computer connected to a home gateway, and are automatically configured in hundreds of millions of devices. They are only intended for use within a private context and traffic that needs to cross the Internet will need to use a different, unique address.
Comment:
Comment: These addresses can be used by anyone without any need to coordinate with IANA or an Internet registry. The traffic from these addresses does not come from ICANN or IANA. We are not the source of activity you may see on logs or in e-mail records. Please refer to http://www.iana.org/abuse/answers
Comment:
Comment: These addresses were assigned by the IETF, the organization that develops Internet protocols, in the Best Current Practice document, RFC 1918 which can be found at:
Comment: http://datatracker.ietf.org/doc/rfc1918
Ref: https://rdap.arin.net/registry/ip/10.0.0.0



OrgName: Internet Assigned Numbers Authority
OrgId: IANA
Address: 12025 Waterfront Drive
Address: Suite 300
City: Los Angeles
StateProv: CA
PostalCode: 90094
Country: US
RegDate:
Updated: 2012-08-31
Ref: https://rdap.arin.net/registry/entity/IANA


OrgAbuseHandle: IANA-IP-ARIN
OrgAbuseName: ICANN
OrgAbusePhone: +1-310-301-5820
OrgAbuseEmail: abuse@iana.org
OrgAbuseRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN

OrgTechHandle: IANA-IP-ARIN
OrgTechName: ICANN
OrgTechPhone: +1-310-301-5820
OrgTechEmail: abuse@iana.org
OrgTechRef: https://rdap.arin.net/registry/entity/IANA-IP-ARIN

Other documented addresses in 10.0.0.0/24

The 10.0.0.0/24 subnet runs from 10.0.0.1 to 10.0.0.254, with 10.0.0.255 reserved as the broadcast address. These are the addresses in it we hold router login details for.

Most looked up in this subnet

10.0.0.5 10.0.0.8 10.0.0.253 10.0.0.251 10.0.0.245 10.0.0.36 10.0.0.254 10.0.0.24

All addresses we cover here
10.0.0.2 10.0.0.4 10.0.0.5 10.0.0.6 10.0.0.7 10.0.0.8 10.0.0.9 10.0.0.10 10.0.0.12 10.0.0.14 10.0.0.15 10.0.0.16 10.0.0.18 10.0.0.24 10.0.0.25 10.0.0.26 10.0.0.27 10.0.0.32 10.0.0.33 10.0.0.35 10.0.0.36 10.0.0.39 10.0.0.40 10.0.0.42 10.0.0.43 10.0.0.44 10.0.0.45 10.0.0.46 10.0.0.52 10.0.0.53 10.0.0.54 10.0.0.55 10.0.0.56 10.0.0.59 10.0.0.63 10.0.0.64 10.0.0.65 10.0.0.66 10.0.0.67 10.0.0.71 10.0.0.75 10.0.0.76 10.0.0.77 10.0.0.81 10.0.0.85 10.0.0.90 10.0.0.91 10.0.0.95 10.0.0.97 10.0.0.124 10.0.0.143 10.0.0.172 10.0.0.181 10.0.0.245 10.0.0.249 10.0.0.250 10.0.0.251 10.0.0.252 10.0.0.253 10.0.0.254

255 addresses in this subnet have a page; the most looked-up are listed here.